dalong@dalonmachine.com

+86-13567788178

Product Categories

Contact Dalong Machinery


Address: 707#,Binhai 8th Rd., Wenzhou Eco&Tech Development Zone, Longwan District, Wenzhou, Zhejiang, China


CONTACT: Sally Young

Cell:+86 13567788178


TEL:  +86-577-86526789

FAX: +86-577-86502588


Sales Email: 

dalong@dalonmachine.com

overseasales@dalonmachine.com


Website: 

www.dalongmachinery.com

https://dalonmachine.en.alibaba.com 

 

WhatsApp:+86 13567788178

WhatsApp:+86 15869602225


Home > News > Content
Moulding Machine Also Called Out Of The Box Machine Aug 29, 2017

Forming machine, also known as open box machine is automatically completed out of the box, forming, under the end of folding folds. And now complete the next part of the tape paste, will be stacked into the cardboard box open, the bottom of the box according to a certain procedure equivalent, and sealed with a tape to the packing machine after the special equipment. Automatic carton molding machine, automatic out of the box is a large number of cartons automatically out of the box, automatically folded under the cover, automatic sealing the bottom of the tape assembly line equipment, the machine all use PLC + display control, greatly facilitate the operation is essential for automated scale production device of.

The working principle of the molding machine is similar to that of the injector, which is the injection of a plasticized molten state (ie, viscous) into the closed cavity by means of the thrust of the screw (or plunger) The process of obtaining the finished product after curing.

Injection molding is a cycle of the process, each cycle mainly include: quantitative feeding - melt plasticization - pressure injection - filling mold cooling - Kaiqi pickup. Remove the plastic parts and then closed the mold, the next cycle.

Method of operation:

⒈ choose to flatten the table, a steady machine, you can pull the chassis feet to facilitate the observation of the machine panel.

⒉ insert the plug on the head of the hand sensor into the socket on the panel and tighten. Attention to positioning gap

⒊ Plug the end of the power cord into the socket on the rear panel of the chassis and the other end into the power supply socket. Be sure to use single-phase three-wire power supply.

⒋ Open the power switch (POWER SW.) On the rear panel of the chassis and press the "SWITCHING" button on the panel. The "WARM UP" green indicator will light and the machine will work.

⒌ hold down the "SET button BUTTON" key, set to the appropriate value, usually between 0.5-2.0 seconds.

⒍ put the sensor head on the top of the container cover, press the handle on the start button, then "HEATING" red light, that is heating, the sensor head do not remove, "HEATING" red light off And then remove the sensor head, and so on "WARM UP" green light or the machine buzzer short "beep" prompts and then the next container can be sealed.

⒎ Check the sealing quality, according to different materials, diameter containers and production efficiency, appropriate dressing "SET button (SETTING BUTTON) button, making the best sealing quality.